Vintage Corner: Henry Adler adjustable practice pad, 1940s

I’ve been looking for one of these for a very long time. I had all but given up hope when suddenly this one appeared online for sale. I hesitated for a few days, then finally decided to go ahead and buy it.

It arrived in complete and functional condition.

As the photos make clear, the pad is in surprisingly good shape for being almost eighty years old.

However, the rubber was hardened and deeply cracked with age and exposure [to sunlight], and in its original condition wasn’t really playable.

After researching possible ways to renew the rubber, it became clear that the damage was too great, and I would either have to let it be or replace it.

I took a couple of days to consider my options.

Leaving the pad as is would mean that it would be relegated to a strictly historical artifact, a museum piece destined for a plexiglas glass display case and inertia.

Replacing the rubber surface would greatly reduce its historical value — and possibly its monetary value —  to collectors. But it would also make the pad playable again.

I had to be honest with myself and admit that I had always hoped to find one in playable condition. But before I took the leap, I sought opinions on fellow drum pad enthusiasts.

Most encouraged me to make the pad playable again, and after considering all the responses and my own feelings, that’s what I ended up doing.

Removing the original rubber was a slow, painstaking process. I took my time, not wanting to damage the wood underneath. I lightly sanded down the wood surface to remove the worst of the glue and allow the replacement rubber to lay flat.

Then, I selected a 1/8” thick piece of gum rubber and trimmed it to match the shape and size of the original, so that the overall aesthetic wouldn’t be too altered. I had considered using 1/4” thick rubber, but I decided on something that would give me greater articulation and also allow for a wider range of volumes without my having to hit the pad so hard. It IS almost eighty years old, after all.

I carefully glued and weighted down the rubber on the wood, let it dry and tested it. So far, so good.

Finally, because the wood was unfinished as far as I could tell, I decided to seal it with a clear coat of wood hardener, which would protect and strengthen the wood surface all around. It would also protect what remained of the decal, which shows Henry Adler’s name and the address of his New York shop and studio. (If you click on Henry’s name above, it will take you to an interview with him by Jim Dinella. I own pads from each of them now.)

(Later versions of this pad would carry a decal from George Way, who’d been licensed by Adler to produce and sell the pads. These later models also had a metal lever rather than a wooden knob, and were painted red or green like Way’s other pad offerings. When George Way was bought out by Camco, the Adler pad was no longer made. 

Here is a later version of the Adler design, sold by George Way in the 1950s. Note the sliding metal lever, and that the doors are hinged at the top rather than the bottom.

Adler’s design was patented in 1946 and the pad was in production for less than ten years total. I believe mine is an early edition of this pad dating from the late 1940s.)

The original white “feet” were very small and one was missing. I removed them all and swapped in some  slightly larger white feet from a Ludwig pad. They tapped into the existing nail holes nicely.

The whole thing was allowed to dry outside under cover from the rain all day. When it stopped being smelly, I brought it indoors to become accustomed to the indoor temperature, and I was done.

I’m not sorry that I brought this pad back to life. I’m pleased with how it turned out and will enjoy it for a very long time.